Home > Products/Support> TAB Handler 
AH9710     TAB Handler

The AH9710 is a high-cost-performance auto handler for TCP and COF, which tests the electrical characteristics of ICs inner-bonded to the tape carrier of 35mm, 48mm and 70mm width. 

The TAB tape is sent from the supply reel (up) to the test site at any set pitch and positioned very accurately with respect to X and Y directions. Then the electrical characteristics are tested by the contactor which is connected to the tester. Based on the test results, the tested IC is sorted and the TAB is wound on the receive reel (down). All the processes are automatically performed. 
・Simple initial setup
 Needle alignment assistant function (X/Y/θ/Z)
 Tape set assistant function
・Active tension control
 Reel motor torque management
 Pneumatic back tension mechanism
・Improved Image-processing
 Detecting resolution / accuracy is improved by enhanced
・Punch unit
 Multiple sorting is available by flexible category setup
 and combination of mark punch.
・Network connection
 Enables remote monitor/control on test result via Ethernet.

 Width & Type
5mmW, 48mmW, 70mmW, 35mmSW, 48mmSW TCP/COF
 Applicable Reels
Max. Diameter φ620mm
 Parallel Testing quantity
Maximum 8pcs (1x1 - 1x8)
ST6730 Test system (Yokogawa Electric)
ST6730A Test system (Yokogawa Electric)
* Please consult when connecting with other testers
 Tester Docking Method
 Tester Interface
TTL (Max. 4 parallel test)
Copyright © TESEC Corporation. All Rights Reserved.